Palm TUNGSTEN T2 User Manual Page 375

  • Download
  • Add to my manuals
  • Print
  • Page
    / 502
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 374
Conducting IR HotSync operations
361
4. In the Select User dialog box, select the user name you entered when you
installed the Palm Desktop software, and click OK.
The HotSync Progress dialog box reappears, and synchronization begins.
5. Wait for a message on your handheld indicating that the process is complete.
After the HotSync process is complete, you can remove your handheld from the
cradle/cable. Gently tilt your handheld forward in the cradle/cable, and then
lift it up to remove it.
Conducting IR HotSync operations
You can use the infrared (IR) port on your handheld to perform HotSync
operations. When you perform an IR HotSync operation, you don’t need your
cradle/cable. However, you must have a computer that’s equipped with an IR port
and that supports the IrCOMM implementation of the Infrared Data Association
(IrDA) standards. This is especially useful if you travel with an infrared-enabled
laptop. You simply enable infrared communication on your laptop and handheld
and follow the steps in “Performing an IR HotSync operation” later in this section.
Preparing your computer for infrared communication
Before you can perform a HotSync operation using the IR port, the computer with
which you want to synchronize must fulfill these requirements:
Your computer must support the IrCOMM implementation of the IrDA
standards.
Your computer must have an enabled infrared port that’s built into the
computer, or an enabled infrared device attached to the computer.
Shown with Mac OS X
Shown with Mac OS X
Page view 374
1 2 ... 370 371 372 373 374 375 376 377 378 379 380 ... 501 502

Comments to this Manuals

No comments